All issues

Search results

3P-bed leveling Z-adjust

Status: Open.

#126 In TinkerGnome/Ultimaker2Marlin;

· Berend1953 opened on Feb 9, 2025

XY Calibration Issue / Implementation Suggestion to TinkerWare

Status: Open.

#125 In TinkerGnome/Ultimaker2Marlin;

· St1ckN1nja opened on Feb 21, 2024

G4 (Dwell) should not send action:pause / action:resume

Status: Open.

#124 In TinkerGnome/Ultimaker2Marlin;

· Aimeethyst opened on Jan 18, 2024

Ulticontroller dead, need replacement

Status: Open.

#122 In TinkerGnome/Ultimaker2Marlin;

· acca84 opened on Nov 2, 2023

Machine occasionally unloads filament at the end of a print run 18.11.1

Status: Open.

#120 In TinkerGnome/Ultimaker2Marlin;

· JeffDM2 opened on May 30, 2023

does not compile due to type mismatch

Status: Open.

#119 In TinkerGnome/Ultimaker2Marlin;

· goguelnikov opened on Mar 16, 2023

Forum post link is dead in README.md

Status: Open.

#117 In TinkerGnome/Ultimaker2Marlin;

· ericderace opened on Nov 8, 2022

Ultimaker 2+ Led Settings don’t stick

Status: Open.

#115 In TinkerGnome/Ultimaker2Marlin;

· mrWheel opened on Sep 25, 2021

Pause mid print and large retraction

Status: Open.

#114 In TinkerGnome/Ultimaker2Marlin;

· frez-knee opened on Sep 8, 2021

Ultimaker 2+ ERROR - Stopped X or Y switch broken

Status: Open.

#111 In TinkerGnome/Ultimaker2Marlin;

· Fullmelon opened on Jan 28, 2021

Different Offset each print UM2+

Status: Open.

#110 In TinkerGnome/Ultimaker2Marlin;

· Sisko4 opened on Dec 23, 2020

50W heater cartridge - changes needed?

Status: Open.

#108 In TinkerGnome/Ultimaker2Marlin;

· Sisko4 opened on Nov 18, 2020